 |
|||
|
Page Title:
Contractor furnished inspection equipment |
|
||
| ||||||||||
|
|  MIL-E-50748(MU)
8 August 1973
TABLE V
I N S P E C T I O N EQUIPMENT
4.5.2 Contractor furnished inspection equipment.
4.5.2.1 Government design. Unless otherwise specified in the
contract, all inspection equipment specified by drawing number in
specifications or- SQAPs forming a p-art of the contract- shall be supplied
by the contractor in accordance with applicable technical data listed in
the TDP.
4.5.2.2 Contractor design. The contractor shall design and supply
inspection equipment compatible with the test methods and procedures
specified in 4. 6 of this specification and with the component inspection
procedures specified in examination and test facilities provisions of MIL-
F-13926. Since tolerance of inspection equipment is normally considered
to be within 10 percent of the product tolerance for which it is intended, this
inherent error in the inspection equipment design must be considered as
part of the prescribed product tolerance limit. Thus, concept, construction,
materials, dimensions, and tolerances used in the design of inspection
equipment shall be so selected and controlled as to insure that the inspection
equipment will reliably indicate acceptability of the product which does not
exceed 90 percent of the prescribed tolerance limit and permit positive
rejection when nonconforming. Construction shall be such as to facilitate
routine calibration of inspection equipment,
4.6 Test methods and procedures.
4.6.1 Test conditions. Unless otherwise specified, the test condi-
tions shall be in accordance with the test facilities provisions of
MIL-F-13926.
9
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals