 |
|||
|
|
|||
| ||||||||||
|
|  MIL-E-52649B
5.3 Marking. In addition to any special marking specified in the contract
or purchase order (see 6.2), marking shall be in accordance with MIL-STD-129.
5.4 Palletization. When required (see 6.2), unitized loads, for levels A,
B, or C shall be palletized in accordance with MIL-STD-147. Palletized loads
shall be uniform in size and quantities to the greatest extent possible. If
the container is of a size that does not conform to any of the pallet patterns
specified in MIL-STD-147, the pallet pattern shall first be approved by the
contracting officer (see 6.2).
6.
NOTES
(This section contains information of a general or explanatory nature that
may be helpful, but is not mandatory.)
6.1 Intended use. The primer equipment is intended as permanent
installation for cold starting internal combustion engines, utilizing ether
engine primer fuel in accordance with O-F-1044.
6.2 Acquisition requirements.
Acquisition documents should specify the
following:
Title, number, and date of this specification.
Type and size of primer equipment required (see 1.2).
b.
Issue of DoDISS to be cited in the solicitation and, if required, the
c.
specific issue of individual documents referenced (see 2.1.1 and 2.2).
When a first article is required for inspection and approval, and the
d.
number of units required (see 3.2, 4.3 and 6.4).
When thermal or cranking controls are required (see 3.7).
e.
When military treatment and painting is required (see 3.9).
f.
When color is other than specified (see 3.9).
g.
Preservation and packing required (see 5.1 and 5.2).
h.
Any special marking (see 5.3).
i.
When palletization is required (see 5.4), and if the pallet pattern
j-
specified does not conform to MIL-STD-147 (see 5.4).
6.3 Technical manuals. The requirement for technical manuals for such
data as technical publications, instructional materials, and supplier's
maintenance and operational manual should be considered when this
specification is applied on a contract.
If technical manuals are required,
military specifications and standards that have been cleared and listed in DoD
5010.12-L, Acquisition Management Systems and Data Requirements Control List
(AMSDL) must be listed on a separate Contract Data Requirements List (DD Form
1423), which is included as an exhibit to the contract. The technical manuals
must be acquired under separate contract line item in the contract.
6.4 First article. When a first article inspection is required, the
item(s) should be a preproduction model. The first article should consist of
one unit. The contracting officer should include specific instructions in
acquisition documents regarding arrangements for examinations, approval of the
11
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals