MIL-F-27707H(USAF)
shall meet consolidated freight rules and regulations or other rules and
regulations applicable to the mode of transportation. The nameplate (see 3.6.2)
shall be packaged in the same carton with each 12 elements or fraction thereof
shipped.
In addition to any special marking required by the con-
5.3 Shipment marking,
tract or order (see 6.2) all shipping containers shall be marked in accordance
with MIL-STD-129. The nomenclature shall be as follows:
FILTER ELEMENT, FLUID, PRESSURE FFU-5/E
NOTES
6.
6.1 Intended use. The FFU-5/E filter element is intended for use as a
replacement item in ground aviation liquid fuel filtering and servicing
systems. This filter element and canister are intended to replace Bowser-Briggs
Division part No. 47B37 and A2653 elements and canisters in the Bowser,
Incorporated, Bowser-Briggs Division model 842D-300 and 842D-600 filter-
separators.
6.1.1 Canisters. It is intended that the canisters will replace the currently
used separator bags in the Bowser, Incorporated, Bowser-Briggs Filtration
Division model 842D-300 and 842D-600 filter-separators, The canisters are not
intended to be replaced each time the element is replaced. Thus the canisters
are intended to be furnished on a one-time basis for the above filter-separators.
Procurement documents should specify the following:
6.2 Ordering data.
a.
Title, number, and date of this specification
b.
When a separator canister is to be furnished (see 3.4.2)
c.
Location and conditions for preproduction testing (see 4.3)
d.
When the test samples are to be other than as specified in 4.3.1
e.
Applicable levels of presentation, packaging, and packing (see 5.1 and 5.2)
f.
Special shipment marking (see 5.3)
6.3 Definition. For the purpose of this specification, the following
definition will apply:
6.3.1 Lot. All filter elements of the same part number manufactured in one
production run and submitted for acceptance at the same time shall be con-
sidered a lot for acceptance purposes.
