|
| MIL-F-45557B
Groups of non-mating parts
Group II
Group I
Arm, anti-backlash (7794550)
Bearing, ball (7794616)
(w/stop, arm 7794574 attached)
(2 required)
(5 required)
Cam, counter (7790490)
Pin, pivot (7794597)
Clevis (7794555)
Shaft, feeder (7791565)
Collar assembly (7794556)
Shaft, lever (7794565)
Housing and guides (w/remaining
Spacer, feeder shaft (7791089)
parts attached) (7791087)
Spring, feeder Shaft (7268573)
Ring, traveling (7794562)
Spring, helical, compression
Spacer, feeder shaft (7791090)
(stop, arms) (7794570)
Spring, helical, compression
(5 required)
(lever shaft) (7794569)
Stripper, front (7794608)
Spring, helical, torsion
(switch shoe) (779459)
Sprocket, rear (7791095)
Group III
Bearing, ball (7794618)
Cam, traveling ring (7794554)
Gear, feeder (7794558)
Shaft, actuating (7794563)
Shoe, switch (7790460)
Spacer, feeder shaft (7794624)
sprocket, front (7791094)
stripper, feeder (7268576)
Support, clevis and solenoid (7794575)
4.6.3.1.2 Concurrent repair parts. Concurrent repair parts shall
be tested for interchangeability requirement by disassembling two feed-
ers, previously tested in 4.6.3.1.1, as necessary and then reassembling
them using the concurrent repair, parts. No hand refinement of parts
will be allowed, and the feeders shall operate and function properly.
This test may be performed independently of the feeder interchange-
ability test specified in 4.663.1.1, and at more frequent intervals
using accepted feeders taken from current production.
4.6.3.2 Interplant. Feeders to be subjected to the interplant
interchangeability test shall be inspected for timing, (see 4.5.2.2.5)
torque, (see 4.5.2.2.6) and functioning requirements using the in-
spection methods specified in 4.6.1 to assure proper operation be-
fore parts are interchanged. Feeders shall be interchanged in a manner
similar to the detailed plan specified in 4.6.3.1.1 except that when
12
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |