 |
|||
|
|
|||
| ||||||||||
|
|  MIL-G-50960(MU)
EL8791668 - Equipment List
EL8791670 - Equipment List
(Copies of specifications, standards, drawings, and publica-
tions required by suppliers in connection with specific
procurement functions should be obtained from the procuring
activity or as directed by the contracting officer.)
3. REQUIREMENTS
3.1 Materials - The contractor shall furnish objective
evidence (see 6.2) that the material complies with the speci-
fications listed on the applicable drawing.
3.2 Assembly. The gasket shall comply with
all requirements specified on the drawing (dwg) 8791668 or
8791670, with all requirements specified herein and with
the requirements of all applicable specifications to the
extent specified on the drawing and herein.
3.3 Workmanship.
3.3.1 Plastic and metal characteristics. All compo-
nents shall be free from cracks, splits, cold flow, shrinkage,
cold shuts, inclusions, porosity,or any similar characteristics.
3.3.2 Burrs. Parts shall be free from burrs.
3.3.3 Foreign matter. Parts shall be free from chips,
dirt, grease, rust, corrosion, or any embedded foreign ma-
terial .
3.3.4 Cleaning. The cleaning method shall not be in;
jurious to any of the parts, nor shall the parts be contaminated
by the cleaning agent.
QUALITY ASSURANCE PROVISIONS
4.
4.1 Responsibility for inspection. Unless otherwise
specified in the contract or purchase order, the supplier
is responsible for the performance of all inspection re-
quirements as specified herein. Except as otherwise spec-
fied in the contract or order, the supplier may use his own
or any other facilities suitable for the performnace of the
inspection requirements specified herein, unless disapproved
by the Government. The Government reserves the right to
perform any of the inspections set forth in the specifica-
tion where such inspections are deemed necessary to assure
supplies and services conform to prescribed requirements.
4.2 First article inspection. Not Applicable.
4.3 Product acceptance inspection.
Inspection lot. A lot or batch and its forma-
4.3.1
ticn, size, and presentation is described in ML-STD-105,
Section 5. Accordingly, a lot shall mean an inspection lot
and a batch shall mean an inspection batch for the purpose
of this specification. The manner in which each inspection
lot or batch is to be presented and identified by the con-
tractor, shall be designated or approved by the Government
representative.
2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals