 |
|||
|
|
|||
| ||||||||||
|
|  MIL-G-5514G
Fitting-Installation of Flared Tube, Straight Thread
MS21344
Connectors, Design Standard For
Retainer, Packing Backup, Continuous Ring, Tetra-
MS27595
fluoroethylene
Packing, Preformed (D-Ring, Shock Strut)
MS28772
Retainer, Packing Backup, Tetrafluoroethylene,
MS28773
Straight Thread Tube Fitting Boss
Retainer, Packing Backup, Single Turn, Tetrafluor-
MS28774
ethylene
Retainer, Preformed, Hydraulic, +275 F (O-Ring)
MS28774
Packing, Preformed, Straight Thread Tube Fitting Boss
MS28778
Retainer, Packing, Back-Up, Teflon
MS28782
Ring, Gasket, Back-up, Teflon
MS28783
Fitting End, Standard Dimensions For Bulkhead Flare-
MS33514
less Tube Connections
Fitting End, Standard Dimensions For Bulkhead Flare-
MS33515
less Tube Connections
Fittings, Installation of Flareless W, Straight-
MS33566
Threaded Connectors
Fitting End, Standard Dimensions For Flared Tube
MS33656
Connection And Gasket Seal
Bosses, Fluid Connection - Internal Straight Thread
MS33649
Fitting End, Standard Dimensions For Bulkhead Flared
MS33657
Tube Connections
(Unless otherwise indicated, copies of federal and military specifications.
standards, and handbooks are available from the Standardization Document
Order Desk, Bldg 4D, 700 Robbins Ave,Philadelphia, PA 19111-5094.)
2.1.2 Other Government documents. drawings, and Publications. The following
other Government documents, drawings, and publications form a part of this
document to the extent specified herein. Unless otherwise specified, the
issues are those cited in the solicitation.
Surface Texture (Surface Roughness, Waviness and Lay)
ANSI/ASME B46.1-85
(Application for copies should be addressed to the American National
Standards Institute, 1430 Broadway, New York NY 10018) .
(Nongovernment standards and other publications are normally available from
the organization which prepare or which distribute the documents. These
documents also may be available in or through libraries or other informa-
tional services.}
2.2 Order of Precedence. In the event of a conflict between the text of this
document and the references cited herein (except for related associated detail
specifications, specification sheets, or MS standards), the text of this
document takes precedence. Nothing in this document, however, supersedes
applicable laws and regulations unless a specific exemption has been obtained.
3.
REQUIREMENTS
3.1
General design requirements for hydraulic units.
3.1.1 Installation of Packings. Mechanisms shall be so designed that no
damage to the packings would be incurred on installation by passing the
packings over threads or other sharp corners. The diameters or threads
3
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals