Gelling Units, Fuel Mark 1, Mod 0 and Mod 1

Page Title: Gelling Units, Fuel Mark 1, Mod 0 and Mod 1
Up | Next

Web
www.tpub.com

Information Categories

....

MIL-G-81737A(AS)

24 August 1984

SUPERSEDING

MIL-G-81737(AS)

14 August 1969

MILITARY SPECIFICATION

GELLING UNITS, FUEL

MARK 1, MOD 0 AND MOD 1

This specification is approved for use by the Naval Air Systems

Command, Department of the Navy, and is available for use by all

Departments and Agencies of the Department of Defense.

1. SCOPE

1.1 Scope. This document covers the minimum requirements for electrically

powered, mechanical gelling units used for the production of gelled fuel for

fire bombs. All gelling units covered by this document have complete dual

voltage (220/440) capabilities.

1.2 Classification. Units shall be wired to the following types as

specified in the contract or purchase order (see 6.2):

Type I

- 220 volts, 60 hertz (Hz), 3 phase

- 440 volts, 60 Hz, 3 phase

Type II

2. APPLICABLE DOCUMENTS

2.1 Government documents.

2,1.1 Specifications, standards, and handbooks. Unless otherwise

specified, the following specifications, standards, and handbooks of the issue

listed in that issue of-the Department of Defense Index of Specifications and

Standards (DoDISS) specified in the solicitation form a part of this

specification to the extent specified herein.

Beneficial comments (recommendations, additions, deletions) and any

pertinent data which may be of use in improving this document should be

addressed to: Engineering Specifications and Standards Department (Code

93), Naval Air Engineering Center, Lakehurst, NJ 08733 by using the

self-addressed Standardization Document Improvement Proposal (DD Form 1426)

appearing at the end of this document or by letter.

FSC 1040

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business