 |
|||
|
Page Title:
Trigger sear and secondary sear test -Cont. |
|
||
| ||||||||||
|
| MIL-L-45935A
AMENDMENT 3
closed position, left hand on the hand guard at a speed to
simulate actual loading and firing of 5 to 10 rounds per 2
minutes. When the barrel is closed, the firing pin shall be
retained by the secondary sear until the trigger is released and
allowed to return to its forward position. When the trigger is
pulled with the index finger of the right hand, the firing pin
shall fall."
4.7.5.1 Change "to and M16 or M16A1 rifle" to "to an M16, M16A1
or M16A2 Rifle".
4.7.7.1.1.1 Delete in its entirety and substitute:
"4.7.7.1.1.1 The launcher receiver, prior to reassemble,
shall be securely held, and using a torque wrench, shall
withstand a torque of 130-10 pound-inches applied to the breech
insert without movement or loosening of the breech insert."
PAGE 16
Table titled: GROUPS OF NONMATING PARTS. Group V Change
"Spring, Ejector (8448307)" to "Spring, Ejector (12006355)".
PAGE 17
4.7.8.1 Change "to an M16 or M16A1 rifle" to "to an M16, M16A1
or M16A2 Rifle".
PAGE 18
*
5.2.1 Add:
"5.2.1 Bar code shall be attached to the receiver IAW the
drawing and shall agree with the serial number."
*
6.1 Add:
"m. Bar code marking requirements."
6.1.1 Delete "4.7.11.7" and substitute: "4.7.8.7".
6.2 Change "and interchangeability and breech insert removal,
etc.)" to "and interchangeability)".
The margins of this amendment are marked with an asterisk or
vertical lines to indicate where changes (additions,
modifications, corrections, deletions) from the previous amendment
were made. This was done as a convenience only and the
6
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals