 |
|||
|
|
|||
| ||||||||||
|
|  MIL-L-85532 (AS)
a.
Yaw. The manipulator head shall impart to the
weapon or store a yaw of 90 degrees both right
and left.
b.
Pitch (tilt) The manipulator head shall impart
to the weapon or store a tilt movement of 15
degrees clockwise or counterclockwise.
c. .
Lateral. The manipulator head shall impart to
the ~'capon or store a total lateral movement of
4 inches.
c?.
Longitudinal. The manipulator head shall impart
to the weapon or store a total longitudinal
movement of 3 inches.
Roll. The manipulator head shall impart to the
e.
.
~'capon or store, a total roll movement of 7
degrees up, and 13 degrees down from the level
position, with load on rollers or adapter of
forks, 360 ,
Forks. With the lifting boom in its lowest position,
3.7.4.3
th fork lift tines shall be easily removable form the manipulator head
and capable of being positioned as follows (see 4.8.2.13).
Top of forks (facing forward) 2 inches above
a.
surface on which loader sits (the tires forward
before fork support).
Top of forks (facing forward) 16 inches above
b.
surface on which loader sits (tines forward
above fork support).
Top of forks (facing aft) 16 inches above
c.
surface on which loader sits (tines aft above
fork support).
Fork tine centers. The manipulator head of the
3.7.4.3.1 :
loader shall be drilled to position the fork tines at distances of 14,
16, 18, 24, 26 and 28 inches between fork centers.
Rollers. The fork tines shall be provided with
3.7.4.3.2
spaced holes for positioning the rollers to accommodate various diameter
k'capons.
Performance requirements.
3.8
Mobility . Loaders supplied under this specification
3.8.1
shall be capable of meeting, without damage, the mobility requirements
listed below. In the event of conflict between this specification and
the drawings listed on DL 1378AS100, the requirements stated on the
drawings shall apply.
10
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals