 |
|||
|
Page Title:
Table 1. Electrical performance characteristics-cont. |
|
||
| ||||||||||
|
|  MIL-M-38510/118B
TABLE I. Electrical performance characteristics Continued.
Conditions 1/ 2/
Device
Limits
Unit
Test
Symbol
type
-55C ≤ TA ≤ +125C
see figure 9 and 3.5
Min
Max
unless otherwise specified
Input voltage
Load current
Output voltage recovery
04
-1.30
-1.20
V
RL = 0.833 Ω,
VIN = -4.25 V,
3/
VOUT
after output short
(RECOV)
CL = 10 F
after IOS1
-1.30
-1.20
circuit current
RL = 250 Ω
VIN = -40 V,
3/
after IOS2
Voltage start-up
04
-1.30
-1.20
V
RL = 0.833 Ω,
VIN = -4.25 V
VSTART
CL = 10 F
Ripple rejection
04
50
dB
ĆVIN /
IL = 500 mA,
VIN = -6.25 V,
6/
ĆVOUT
TA = 25C,
ei = 1 Vrms,
at fo = 2400 Hz
see figure 10
Vrms
04
120
Output noise voltage
VIN = -6.25 V, 4/
IL = 100 mA,
VNO
see figure 11
TA = 25C
Line transient response
04
80
mV/V
ĆVOUT /
VIN = -6.25 V, 5/
IL = 100 mA,
TA = 25C
ĆVIN
ĆVIN = -1.0 V,
see figure 12
Load transient response
04
0.15
mV/mA
ĆVOUT /
VIN = -6.25 V, 5/
IL = 100 mA,
see figure 13
ĆIL
ĆIL = 400 mA
TA = 25C
All tests performed at TA = 125C may at the manufacturer's option, be performed at TA = 150C.
1/
Specifications for TA = 125C shall then apply at TA = 150C.
2/
Static tests with load currents greater than 5 mA are performed under pulsed conditions defined on figure 9.
3/
Output voltage recovery test shall be performed, with the designated load conditions, immediately after removal
of each IOS test forced output voltage condition.
4/
The meter for ei and eo shall have a minimum bandwidth from 10 Hz to 10 kHz and shall measure true rms voltages.
5/
The oscilloscope shall have a bandwidth between 5 and 15 MHz.
6/
The meter for ei and eo shall have a minimum bandwidth from 300 Hz to 10 kHz and shall measure true rms voltage.
13
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals