 |
|||
|
|
|||
| ||||||||||
|
|  MIL-M-38510/125B
1.3 Absolute maximum ratings.
18 V
Supply voltage range .......................................................................
18 V 1/
Input voltage range ..........................................................................
Logic to logic reference differential voltage ......................................
+7 V, -30 V
-65C to +150C
Storage temperature range ..............................................................
Unlimited 2/
Output short-circuit duration .............................................................
+300C
Lead temperature (soldering, 60 seconds) ......................................
+175C 3/
Junction temperature (TJ) ................................................................
Hold capacitor short circuit duration .................................................
10 seconds
1.4 Recommended operating conditions.
Supply voltage range ....................................................................... 5 V to 15 V
Ambient operating temperature range (TA) ...................................... -55C to +125C
Hold capacitor type .......................................................................... Teflon 4/
1.5
Power and thermal characteristics.
Maximum
Case outlines
Maximum allowable power
Maximum
dissipation
θJC
θJA
G
40C/W
150C/W
330 mW at TA = +125C
P
35C/W
120C/W
400 mW at TA = +125C
2. APPLICABLE DOCUMENTS
2.1 General. The documents listed in this section are specified in sections 3, 4, or 5 of this specification. This
section does not include documents cited in other sections of this specification or recommended for additional
information or as examples. While every effort has been made to ensure the completeness of this list, document
users are cautioned that they must meet all specified requirements of documents cited in sections 3, 4, or 5 of this
specification, whether or not they are listed.
2.2 Government documents.
2.2.1 Specifications, standards, and handbooks. The following specifications and standards form a part of this
specification to the extent specified herein. Unless otherwise specified, the issues of these documents are those
cited in the solicitation or contract.
DEPARTMENT OF DEFENSE SPECIFICATIONS
MIL-PRF-38535
- Integrated Circuits (Microcircuits) Manufacturing, General Specification for.
DEPARTMENT OF DEFENSE STANDARDS
MIL-STD-883
- Test Method Standard for Microelectronics.
MIL-STD-1835
- Interface Standard Electronic Component Case Outlines.
(Copies of these documents are available online at http://assist.daps.dla.mil/quicksearch/ or
http://assist.daps.dla.mil or from the Standardization Document Order Desk, 700 Robbins Avenue, Building 4D,
Philadelphia, PA 19111-5094.)
______
1/ The absolute maximum input voltage shall not exceed the power supply voltages.
2/ Short circuit may be to ground or either supply. Rating applies to +125C case temperature or +75C
ambient temperature.
3/ For short term test (in the specific burn-in and life test configuration when required and up to 168 hours
maximum), TJ = 275C.
4/ Sample and hold performance is highly dependent on having a quality "hold" capacitor with low dielectric
absorption over 55C ≤ TA ≤ 125C.
2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals