 |
|||
|
|
|||
| ||||||||||
|
|  MIL-M-38510/140A
3.4 Lead material and finish. The lead material and finish shall be in accordance with MIL-PRF-38535 (see 6.6).
3.5 Electrical performance characteristics. The electrical performance characteristics are as specified in table I,
and apply over the full recommended ambient operating temperature range, unless otherwise specified.
The following conditions shall also apply unless otherwise specified:
Unipolar operation
VFSR = 10 V
VCC = +15.0 V
VEE = -15 V
Logic "0" = 0.8 V maximum
CS input = logic "0"
CE input = logic "1"
Logic "1" = 2.0 V minimum
VLOG = +5.0 V
12/ 8 input = V
-55C ≤ TA ≤ +125C
3.6 Electrical test requirements. Electrical test requirements for each device class shall be the subgroups
specified in table II. The electrical tests for each subgroup are described in table III.
3.7 Marking. Marking shall be in accordance with MIL-PRF-38535.
3.7.1 Correctness of indexing and markings. All devices shall be subjected to the final electrical tests subgroups 1
and 4 specified in table II after part marking to verify that they are correctly indexed and identified by part number.
Optionally, an approved electrical test may be devised especially for this requirement.
3.8 Microcircuit group assignment. The devices covered by this specification shall be in microcircuit group H
and number 57 (see MIL-PRF-38535, appendix A).
4
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals