 |
|||
|
|
|||
| ||||||||||
|
|  MIL-M-38510/141B
3. REQUIREMENTS
3.1 Qualification. Microcircuits furnished under this specification shall be products that are manufactured by a
manufacturer authorized by the qualifying activity for listing on the applicable qualified manufacturers list before
contract award (see 4.3 and 6.4).
3.2 Item requirements. The individual item requirements shall be in accordance with MIL-PRF-38535 and as
specified herein or as modified in the device manufacturer's Quality Management (QM) plan. The modification in the
QM plan shall not affect the form, fit, or function as described herein.
3.3 Design, construction, and physical dimensions. The design, construction, and physical dimensions shall be as
specified in MIL-PRF-38535 and herein.
3.3.1 Terminal connections and logic diagram. The terminal connections and logic diagram shall be as specified
on figure 1.
3.3.2 Truth table and logic equations. The truth table and logic equations shall be as specified on figure 2.
3.3.3 Schematic circuits. The schematic circuits shall be maintained by the manufacturer and made available to
the qualifying activity and the preparing activity upon request.
3.3.4 Case outlines. The case outlines shall be as specified in 1.2.3.
3.3.5 Package and sealing material. Package and sealing material shall be in accordance with MIL-PRF-38535.
3.4 Lead material and finish. The lead material and finish shall be in accordance with MIL-PRF-38535 (see 6.6).
3.5 Electrical performance characteristics. The electrical performance characteristics are as specified in table I,
and apply over the full recommended ambient operating temperature range, unless otherwise specified.
3.6 Electrical test requirements. Electrical test requirements for each device class shall be the subgroups
specified in table II. The electrical tests for each subgroup are described in table III.
3.7 Marking. Marking shall be in accordance with MIL-PRF-38535.
3.7.1 Serialization. All class S devices shall be serialized in accordance with MIL-PRF-38535.
3.7.2 Correctness of indexing and markings. All devices shall be subjected to the final electrical tests specified in
table II after part marking to verify that they are correctly indexed and identified by part number. Optionally, an
approved electrical test may be devised especially for this requirement.
3.8 Microcircuit group assignment. The devices covered by this specification shall be in microcircuit group number
53 (see MIL-PRF-38535, appendix A).
3
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals