 |
|||
|
|
|||
| ||||||||||
|
|  MIL-M-38510/141B
TABLE IV. Group C end-point electrical parameters. TA = +25C
Test
Limits
Delta
Unit
Min
Max
Min
Max
A
---
10.0
-0.5
+0.5
ICEX
1000
---
-25%
25%
---
hFE
6. NOTES
6.1 Intended use. Microcircuits conforming to this specification are intended for original equipment design applications and
logistic support of existing equipment.
6.2 Acquisition requirements. Acquisition documents should specify the following:
a.
Title, number, and date of the specification.
b.
Pin and compliance identifier, if applicable (see 1.2).
c.
Requirements for delivery of one copy of the conformance inspection data pertinent to the device
inspection lot to be supplied with each shipment by the device manufacturer, if applicable.
d.
Requirements for certificate of compliance, if applicable.
e.
Requirements for notification of change of product or process to acquiring activity in addition to
notification of the qualifying activity, if applicable.
f.
Requirements for failure analysis (including required test condition of MIL-STD-883, method 5003),
corrective action and reporting of results, if applicable.
g.
Requirements for product assurance options.
h.
Requirements for special carriers, lead lengths, or lead forming, if applicable. These requirements should not
affect the part number. Unless otherwise specified, these requirements will not apply to direct purchase by
or direct shipment to the Government.
i.
Requirements for "JAN" marking.
j.
Packaging requirements (see 5.1).
6.3 Superseding information. The requirements of MIL-M-38510 have been superseded to take advantage of the
available Qualified Manufacturer Listing (QML) system provided by MIL-PRF-38535. Previous references to MIL-M-38510 in
this document have been replaced by appropriate references to MIL-PRF-38535. All technical requirements now consist of this
specification and MIL-PRF-38535. The MIL-M-38510 specification sheet number and PIN have been retained to avoid
adversely impacting existing government logistics systems and contractor's parts lists.
6.4 Qualification. With respect to products requiring qualification, awards will be made only for products which are, at the
time of award of contract, qualified for inclusion in Qualified Manufacturers List QML-38535 whether or not such products have
actually been so listed by that date. The attention of the contractors is called to these requirements, and manufacturers are
urged to arrange to have the products that they propose to offer to the Federal Government tested for qualification in order that
they may be eligible to be awarded contracts or purchase orders for the products covered by this specification. Information
pertaining to qualification of products may be obtained from DSCC-VQ, 3990 E. Broad Street, Columbus, Ohio 43123-1199.
95
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals