6.6 Logistic support. Lead materials and finishes (see 3.3) are interchangeable. Unless otherwise specified,
microcircuits acquired for Government logistic support will be acquired to device class B (see 1.2.2), lead material
and finish A (see 3.4). Longer lead lengths and lead forming should not affect the part number.
6.7 Substitutability. The cross-reference information below is presented for the convenience of users.
Microcircuits covered by this specification will functionally replace the listed generic-industry type. Generic-industry
microcircuit types may not have equivalent operational performance characteristics across military temperature
ranges or reliability factors equivalent to MIL-M-35810 device types and may have slight physical variations in relation
to case size. The presence of this information should not be deemed as permitting substitution of generic-industry
types for MIL-M-38510 types or as a waiver of any of the provisions of MIL-PRF-38535.
6.8 Manufacturers' designation. Manufacturers' circuits included in this specification are designated as shown in
table IV herein.
TABLE IV. Manufacturers designator.
6.9 Changes from previous issue. The margins of this specification are marked with vertical lines to indicate where
changes from the previous issue were made. This was done as a convenience only and the Government assumes no
liability whatsoever for any inaccuracies in these notations. Bidders and contractors are cautioned to evaluate the
requirements of this document based on the entire content irrespective of the marginal notations and relationship; to
the last previous issue.
Army - CR
DLA - CC
Navy - EC
Air Force - 11
DLA - CC
Army - MI, SM
Navy - AS, CG, MC, SH, TD
Air Force - 03, 19, 99
NOTE: The activities listed above were interested in this document as of the date of this document. Since
organizations and responsibilities can change, you should verify the currency of the information above using the
ASSIST Online database at http://assist.daps.dla.mil.