 |
|||
|
Page Title:
Recommended operating conditions. |
|
||
| ||||||||||
|
|  MIL-M-38510/758B
1.3 Absolute maximum ratings. 1/ 2/
Supply voltage range (VCC) ........................................................................................
-0.5 V dc to +6.0 V dc
DC input voltage range (VIN) ......................................................................................
-0.5 V dc to VCC + 0.5 V dc
DC output voltage range (VOUT) .................................................................................
-0.5 V dc to VCC + 0.5 V dc
20 mA
Clamp diode current (IIK, IOK) .....................................................................................
50 mA
DC output current (IOUT) .............................................................................................
50 mA times the number of outputs
DC VCC or GND current (ICC, IGND) .............................................................................
-65C to +150C
Storage temperature range (TSTG) .............................................................................
Maximum power dissipation (PD) ...............................................................................
500 mW
+300C
Lead temperature (soldering, 10 seconds) ................................................................
Thermal resistance, junction-to-case (θJC) .................................................................
See MIL-STD-1835
+175C
Junction temperature (TJ) ..........................................................................................
-55C to +125C
Case operating temperature range (TC).....................................................................
1.4 Recommended operating conditions. 2/ 3/ 4/
Supply voltage range (VCC) ........................................................................................
+3.0 V dc to +5.5 V dc
Input voltage range (VIN) ............................................................................................
+0.0 V dc to VCC
Output voltage range (VOUT).......................................................................................
+0.0 V dc to VCC
-55C to +125C
Case operating temperature range (TC).....................................................................
Maximum low level input voltage(VIL) ........................................................................
0.90 V dc at VCC = 3.0 V dc
1.35 V dc at VCC = 4.5 V dc
1.65 V dc at VCC = 5.5 V dc
Minimum high level input voltage (VIH)....................................................................... 2.10 V dc at VCC = 3.0 V dc
3.15 V dc at VCC = 4.5 V dc
3.85 V dc at VCC = 5.5 V dc
Input rise and fall rate (tr, tf) maximum:
VCC = 3.6 V, VCC = 5.5 V ......................................................................................... 8 ns/V
1.5 Radiation features.
Device types 02 and 03:
Total dose available (dose rate = 50 300 rads (Si)/s) ........................................... 100 krads (Si)
Single Event Latch-up (SEL) ................................................................................... ≥120 MeV-cm2/mg
1/ Stresses above the absolute maximum rating may cause permanent damage to the device. Extended operation at the
maximum levels may degrade performance and affect reliability. The maximum junction temperature may be exceeded for
allowable short duration burn-in screening conditions in accordance with MIL-PRF-38535.
2/ Unless otherwise noted, all voltages are referenced to GND.
3/ Operation from 2.0 V dc to 3.0 V dc is provided for compatibility with data retention and battery back-up systems. Data
retention implies no input transitions and no stored data loss with the following conditions: VIH ≥ 70 percent of VCC, VIL ≤ 30
percent of VCC, VOH ≥ 70 percent of VCC at 20 A, VOL ≤ 30 percent of VCC at 20 A.
4/ Unless otherwise specified, the values listed above shall apply over the full VCC and TC recommended operating range.
2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals