 |
|||
|
|
|||
| ||||||||||
|
|  MIL-M-45405C(AR)
4.5.5 Mine functioning. The mines shall be functioned against
three-inch, homogeneous armor plate, complying with MIL-A-13812,
placed normal to the line of fire, at a 21 inch standoff. The test
Remove the closing plug from the
shall be conducted as follows:
mine, insert an M120 Booster from an accepted lot and replace the
Remove the shipping plug from the top of the mine and
closing plug.
from the M607 Fuze Adapter and assemble an M607 combination mine
Emplace the assembly in
fuze from an accepted lot to the mine.
firm, level ground so that the top of the mine cover is three inches
below the top of the ground.
Soil shall be tapped firmly around the
mine to prevent it from tilting.
The plastic collar of the fuze
shall be kept free from earth.
CAUTION:
The fuze shall be armed by remote control with all
personnel behind a suitable barricade. The fuze shall be armed by
attaching a lanyard to the safety pin ring and around the safety
support in such a manner that a pull on the lanyard will entirely
remove the safety pin before any tension is placed on that portion
of the lanyard which is connected to the safety support.
Before
pulli ng the lanyard, squeeze together the ends of the safety pin to
enable the pin to slide easily out of the pin hole. Actuate the
fuze by tilting the fuze extension rod. For information only, the
load required to function the fuze is 5 1/4 plus or minus 1 1/2
pounds when activating the fuze by tilting the extension rod at the
extreme end. Observation shall be made for Satisfactory functioning
as indicated by a typical penetration as shown on figures 1 and 2.
This test shall be performed as
4.5.6 Heat seal test.
specified in MIL-P-116.
PACKAGING
5.
5.1 Packing.
5.1.1 Level A.
Packing for Mine, AT, M21, with booster
assembly, M120, and fuze, mine combination, M607, shall be in
accordance with Dwg. 8830860.
5.1.2 Level B.
Packing shall be as specified in 5.1.1.
5.1.3
Level C.
Packing shall be as specified in 5.1.1.
5.2 Marking.
Marking shall be in accordance with Dwg. 8830860.
When mines from more than one lot are shipped at
5.3 Shipping.
one time, each lot shall be kept separate, and the division between
lots clearly indicated to prevent mixing of the lots in transit.
6.
NOTES
6.1
Ordering data.
See MIL-A-48078.
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals