24 February 1992
14 September 1984
MOLDING MATERIAL, GLASS, EPOXY IMPREGNATED
This specification is approved for use by the U.S. Army Missile Command,
Department of the Army, and is available for use by all Departments and
Agencies of the Department of Defense.
1.1 Scope. This specification covers one type of epoxy impregnated glass
2. APPLICABLE DOCUMENTS
2.1 Government documents.
2.1.1 Specifications, standards, and handbooks. The following specifications,
standards, and handbooks form a part of this document to the extent specified herein.
Unless otherwise specified, the issues of these documents are those listed in the issue
of the Department of Defense Index of Specifications and Standards (DODISS) and
supplement thereto, cited in the solicitation (see 6.2).
Beneficial comments (recommendations, additions, deletions) and any pertinent data
which may be of use in improving this document should be addressed to: Commander,
U.S. Army Missile Command, ATTN; AMSMI-RD-SE-TD-ST, Redstone Arsenal,
AL 35898-52770 by using the Standardization Document Improvement Proposal (DD
Form 1426) appearing at the end of this document or by letter.
DISTRIBUTION STATEMENT A. Approved for public release; distribution is