 |
|||
|
|
|||
| ||||||||||
|
|  MIL-N-81604C(AS)
Para 3.5.1.9.1c
(cont)
X Gyro Torquer Test Point - This test point
(14)
signal shall monitor the output of the X gyro
torquer pulse train, which has a nominal
frequency of 150 cycles Per second (zero rate).
For a full torque rate of +60/hr, the signal
*
shall be a d-c level of +150 25 millivolts
when looking into an open circuit. A full
*
torque of -60/hr results in a d-c voltage
*
-
level of -150 25 millivolts when looking
into an open circuit. The pulse width charac-
*
teristics and scale factor per pulse is
*
described more fully in 3.4.4.1e.
Y Gyro Torquer Test Point - This test point
(15)
signal shall monitor the output of the Y gyro
torquer pulse train which has a nominal
frequency of 150 cycles per second (zero rate).
The voltage levels are the same as for the
X gyro torquer test point.
z Gyro Torquer Test Point - This test point
(16)
signal shall monitor the output of the Z gyro
torquer pulse train, which has a nominal
frequency of 150 cycles per second (zero rate).
The voltage levels are the same as for the
X gyro torquer test point.
Azimuth Servo Monitor - This signal shall be
(17)
*
an analog d-c test point which monitors the
*
output of the azimuth servo amplifier. It
varies from a nominal zero volts to plus or
minus 5 volts at maximum output.
Pitch Servo Monitor - This signal shall be an
(18)
analog d-c test point which monitors the output *
of the pitch servo amplifier with the same
characteristics as the Azimuth Servo Monitor.
Inner Roll Servo Monitor - This signal shall
(19)
be an analog test point which monitors the
*
output of the inner roll servo amplifier
with the same characteristics as the Azimuth
Servo Monitor.
97
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals