 |
|||
|
Page Title:
Table II. Instructions for Testing |
|
||
| ||||||||||
|
|  MIL-P-10831B
AMENDMENT 4
3.9:
Delete in its entirety and substitute:
"3.9 Pick strength. The pick strength, or the surface bond strength,
of the printing side (see 3.4.1) of the paper shall withstand not less
than the values specified below with no picking, when tested as specified
in Table II:
Type I
Nr6A
Dennison Standard Wax
Type II
Nr8A
Dennison Standard Wax"
3.10:
Delete "6 + 0.5 ph" and substitute "7 + 1.5 ph"
PAGE 14
Delete Table II in its entirety and substitute the following:
TABLE II.
Instructions for Testing
Specification Reference
Requirements
Number
Results Reported
Test (1)
Applicable
Determinations(2)
As Numerically(3)
Characteristics
Requirement
Method
to Lot Avg.
Per Sample Unit
to Nearest
Basis weight
3.5.1, 3.5.2
110
X
1 (Avg. of 5 sheets)
Pound
Thickness
3.6.1, 3.6.2
173
X
Avg. of 3
0.0001 inch
Tear, grams
cross direction
Table I
170
X
Avg. of 5
Grams
Gloss
3.8
T-480M
X
Avg. of 3
Unit
Pick strength
3.9
T-459M
X
Avg. of 3
Number
PH
3.10
200
-
(2) Composite
0.1 ph Unit
Penetration
3.11
4.4.2
X
1 (10 rounds)
10 Percent
Note:
1. Three digit numbers refer to Federal Specification UU-P-31. Numbers
preceded by the letter "T" refer to TAPPI Standard Methods. Test Methods
shall be performed in accordance with the applicable procedures, except that
the stipulation as to the number of specimens to test, number of
determinations to perform or number of results to report, shall be as
indicated in this table. All testing shall be performed under atmospheric
conditions as specified in 4.4.1.
2. The composite shall consist of representative portions taken from each
sample unit and combined into a single sample.
3.
Test reports shall include all values on which results are based.
2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals