 |
|||
|
|
|||
| ||||||||||
|
|  MIL-P-1407C
3.5.1,4 Hinge.- The hinge shall be fabricated of sheet steel specified in
3.2,3 and shall be of a continuous type. The hinge shall be fastened to the
body and lid so that the lid shall set properly on the body without forcing.
The hinge pin shall have a drive fit on one leaf of the hinge with a freely
rotating fit, after painting, on the other leaf.
*
3.5.2 Trays.- The trays shall be fabricated of material specified in 3.2.4.
A finger grip shall be fabricated as shown on the applicable drawing. The pin
holes shall be punched, leaving a flat side bent inward as shown on drawing.
3.5.3 Pins.-
3.5.3.1 Pin body.- The pin body shall be fabricated from material specified
in 3.2.1. The non-pointed end shall have an angle bend or a radius bend and
shall be permanently clamped and staked to the head.
3.5.3.2 Pin head.- The pin head shall be fabricated of material specified
in 3.2.2. The pin shall fit the tray with the head protruding not more than
7/8 inch.
3.6 Finish.-
3.6.1 Surface preparation.- All surfaces and edges shall be free from burrs
and sharp edges prior to finishing,
3.6.2 Carrier case surfaces.- All surfaces of the carrier case shall be
thoroughly cleaned and conditioned for painting in accordance with any method
or type of TT-C-490.
*
3.6.2.1 Priming.- Following surface preparation, all interior and exterior
surfaces of the carrier case shall be completely covered with the primer
specified in 3.2.5, Primer shall be thoroughly dried prior to application of
the enamel.
*
3.6.2.2 Enameling.- The primed surfaces of the carrier case shall be coated
with enamel specified in 3.2.6. The final finish shall be uniform in color,
gloss, and appearance and shall be free of wrinkles, sags, blisters, foreign
matter, or other defects characteristic of improper application.
3.6.3 Pins and trays.- The pins and trays shall have a natural finish and
shall be cleaned of all dirt, oil, and other foreign substances. The pins and
trays shall be marked for identification in accordance with 3.7.
*
3.7 Marking for identification.-
3.7.1 Identification numbering.-
3.7.1.1 Carrier case numbering.- Each carrier case shall have identification
numbering (see 3.3.1.1) stenciled in accordance with MIL-STD-130. The location
and height of the numbering shall be as shown on Drawing 5-7-30.
5
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals