 |
|||
|
Page Title:
Table II. Classification of defects |
|
||
| ||||||||||
|
|  MIL-P-1407C
4.3.3 End item inspection.- The inspection lot shall consist of all completely
fabricated pin sets offered for inspection at one time. The sample unit shall
be one complete pin set.
4.3.3.1 Visual examination.- Examination of the end item shall be made in
accordance with the classification of defects in table 11. The inspection level
shall be level II with an acceptable quality level (AQL) of 2.5 for major defects
and 6.5 for total defects, expressed in terms of defects per hundred units.
Classification of defects
TABLE II.-
Classification
Minor
Major
Examine
Defect
x
Finish
Not as specified
Carrier case
Color does not conform to X24087
Streaks, runs, thick places, poor
coverage, wrinkles and blisters,
foreign matter imbedded in the
x
finish
Pins and trays
Not a natural finish; contains
x
dirt, oil, or foreign matter
Workmanship and
Brass corroded
x
construction
Pins
Head (clasp) not tight Fit to body
x
Not designed as shown on drawing
(unless alternate pin design
x
applicable)
Staking not neat
x
Point not sharp and smooth
x
Tray
Finger grip fractured or sharp
x
Not one piece construction
x
Assembled with less than 3 spot welds
x
Pinholes not punched correctly
(have burred edges)
x
Flat side not bent inward
x
Not 20 pinholes
x
Pinholes in wrong position
x
7
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals