 |
|||
|
|
|||
| ||||||||||
|
|  MIL-P-17639F(SH)
3.7 Technical manuals.
3.7.1 Unless otherwise specified in the contract or order (see 6.2.1),
technical manuals shall be prepared in accordance with type I of MIL-M-15071.
The modifications and clarifications specified in 3.7.2 through 3.7.5 shall
apply. A separate manual shall be furnished for each different pump unit
except in special cases when manuals covering more than one pump may be approved.
Preliminary manuals shall be submitted to the design review agency for approval
and shall include all proposed sections complete. Unless otherwise specified
in the contract or order (see 6.2.1), manuals shall include pump, driver,
controls and all appurtenances and all applicable drawings. Performance curves
for final manuals may be furnished as insert pages after delivery of hardware.
3.7.2 Manuals covering pumps driven by turbines or engines shall include
drawings and full operation and maintenance instructions covering the turbines,
engines, governors and any other applicable accessories.
3.7.3 Manuals covering pumps driven by conventional electric motors with
conventional controllers need not include operation and maintenance instructions
covering the motors and controllers. They shall, however, include master draw-
ings and certification data covering the motors and controllers. Complete
operation and maintenance instructions covering electrical equipment shall be
included when specifically required (see 6.2.1).
3.7.4 Each manual shall include not less than the following illustrations
covering the pump and driver:
(a) Sectional assembly drawing.
(b) Outline drawing.
(c) Complete list of material corresponding to the sectional
assembly drawing.
(d) Certification data.
(e) A minimum of two photographs of the complete unit, pump
and driver, taken 180 degrees apart on a horizontal plane.
Where several sizes of identical design units are being
supplied, photographs of one design unit only need be supplied.
3.7.5 The alinement procedure instructions in the manual shall describe in
complete detail the means by which the required alinement clearance at sleeve
bearings and wearing rings is to be established. The manual shall prescribe the
maximum permissible eccentricities which can be tolerated in the aforementioned
areas with the pump in the assembled condition. Exceptions to any part of the
aforementioned requirements in any specific area may be had only by providing for
design review agency approval a written technical justification for the said
exception. The manual shall specify the maximum allowable clearance for wearing
rings and sleeve bearings before replacement of the parts. In addition, the
manuals shall contain:
34
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals