 |
|||
|
Page Title:
Table VI. On board repair parts. |
|
||
| ||||||||||
|
|  --
MIL-P-17840C(SH)
TABLE VI.
On board repair parts.
Quantity per set
Name of part
100 percent complete re-
Ball bearings
placement for all installed
Felt wiper rings or oil seals
units per ship.
Packing, if special
Mechanical seal
Shaft sleeves
100 percent replacement
Undersize casing wearing
for one pump per ship.
rings
Stuffing box throat bushings
Impeller nuts
6.5.3 Each box containing on board repair parts should contain a list
entitled "List of on board repair parts". The list should be-in a format for
use on outline drawings and in the technical manuals. It should be not less
than nominal 8-1/2 by 11 inches in size.
6.5.3.1 The format of the list should include a heading and columns of
data for the items listed. The heading should include titles and applicable
entries as follows:
Reproduced from drawing number
Number of ships
Application
Contract number
Manufacturer
units
per
ship
Quantities are for
The columns should include:
Piece number
Name of part
Quantity
Drawing number
Federal stock number
Additional columns may be used as applicable.
6.5.3.2 The list should be so treated as to be resistant to oil, water,
and fading.
6.5.4 The repair parts requirements for the drivers and accessories should
be in accordance with the related equipment specification.
6.6 Sub-contracted material and parts. The packaging requirements of
referenced documents listed in section 2 do not apply when material and parts
are acquired by the contractor for incorporation into the equipment and lose
their separate identity when the equipment is shipped.
39
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals