 |
|||
|
|
|||
| ||||||||||
|
|  MIL-P-46530D(AR)
2.3 Order of precedencee. In the event of a conflict between
the text of this specification and the references cited herein,
(except for associated detail specifications, specification sheets
or MS standards) the text of this specification shall take
precedence. Nothing in this specification, however, shall
supersede applicable laws and regulations unless specific
exemption has been obtained.
REQUIREMENTS
3.
3.1 General.
a Material. Materials shall be in accordance with the
applicable drawings and specifications.
b. Manufactureing process. All parts and assemblies shall
be manufactured by a process approved by the contracting officer,
and no deviation from that process shall be made without prior
approval (6.4).
3.2 Components. All parts and assemblies shall comply with
all requirements specified on Drawing (Dwg.) 7258846, all
associated drawings. and with all requirements specified in
applicable specifications.
3.3 First article . When specified in the contract or
purchase order, a sample shall be subjected to a first article
inspection in accordance with the technical provisions herein (see
4.3 and 6.5).
3.4 Banding. The rotating band blank and the rotating band
seat shall be clean at the time of banding. Shot or sandblasting
shall not be used to clean the rotating band seat after knurling.
The rotating band blank shall fill the band seat.
3.5 Soundness. Metal discontinuity in the projectile body as
determined by eddy current inspection shall be less than that
represented by production check standard (PCS) no.1.
3.6 Protective coating.
3.6.1 Phosphate coating. The pretreatment cleaning process
shall be in accordance with the applicable requirements of Dwg.
7258846. The phosphate coating shall be in accordance with the
requirements of TT-C-490 for appearance and minimum weight as
applicable to the type of phosphate coating used. Test specimens
(panels) shall be in accordance with the requirements of TT-C-490.
3.6.2 Paint coating. The exterior coating of the projectile
shall be in accordance with applicable requirements of Dwg.
The exterior paint adhesion shall be in accordance with
7258846.
applicable requirements of TT-C-490.
4
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals