 |
|||
|
|
|||
| ||||||||||
|
|  MIL-P-48451A(MU)
factured in the same manner, using the same materials, equipment, pro-
cesses, and procedures as used in regular production. All parts and mat-
erials, including packaging and packing, shall be obtained from the Same
source of supply as used in regular production.
4.2.1 Government testing.- When the Government is responsible for
conducting first article approval tests, the contractor, prior to sub-
mitting the sample to the Government, shall inspect the sample to insure
that it conforms to all the requirements of the contract and submit a
record of this inspection with the sample, including certificates of
conformance for materials.
4.2.2 Contractor testing.- When the contractor is responsible for
conducting first article approval tests, the sample shall be inspected by
the contractor for all the requirements of the contract. The sample and
a record of this inspection, including certificates of conformance for
materials, shall be submitted to the Government for approval. The Gov-
ernment reserves the right to witness the contractor's inspection.
4.3 Inspection provisions.
4.3.1 Submission of product.- Unless otherwise specified by the
contracting officer, inspection lot size, lot formation and presentation
of lots shall be in accordance with "Submission of Product" provisions
of MIL-STD-105.
4.3.2 Examination and tests.
4.3.2.1 Components and subassemblies.- All components and sub-
assemblies shall be inspected in accordance with the inspection provisions
contained in Supplementary Quality Assurance Provisions (SQAP) listed in
the technical data package (TDP). In the absence of SQAP'S, the applica-
ble Quality Assurance Provisions of MIL-F-13926 shall apply.
4.3.2.2 Periscopes.- Examination and tests related to Section 3
herein shall be performed on a single defect (individual characteristic)
basis in accordance with MIL-STD-105 and the Sampling plans specified in
Tables I, II, III and IV herein. Examination and tests for packaging,
packing and marking shall be in accordance with MIL-P-14232 and Section 5
herein. In addition to 100% inspection as specified in 4.3.2.3, the
tabulated classification of defects in Tables I, II, III and IV shall
constitute the minimum inspection to be performed by the supplier after first
article approval and prior to Government acceptance or rejection by item or lot.
4.3.2.3 100 Percent inspection.- The following requirements and
related tests shall be subjected to 100% inspection:
CHARACTERISTIC
TEST PROCEDURE
REQUIREMENT
1.
Line of sight variation,
daylight viewing area
4.6.6.3.3
3.8.3.1.lc
2.
Line of sight variation,
3.8.3.1.2c
4.6.6.4.3
passive viewing area
8
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals