11 May 1988
8 March 1979
FOR RIBBON BRIDGE TRANSPORTER
This specification is approved for use within the USA Belvoir Research,
Development and Engineering Center, Department of the Army, and is
available for use by all Departments and Agencies of the Department of
1.1 Scope. This specification covers cargo pallets capable of functioning
with the ribbon bridge transporter.
2. APPLICABLE DOCUMENTS
2.1 Government documents.
2.1.1 Specifications, standards, and handbooks. The following
specifications, standards, and handbooks form a part of this specification
to be extent specified herein. Unless otherwise specified, the issues of
these documents shall be those listed in the issue of the Department of
Defense Index of Specifications and Standards (DoDISS) and supplement
thereto, cited in the solicitation.
-Sampling Procedures and Tables for Inspection by
-Marking for Shipment and Storage.
-Slinging and Tiedown Provisions for Lifting and
Tying Down Military Equipment.
Beneficial comments (recommendations, additions, deletions) and any
pertinent data which may be of use in improving this document should be
addressed to: USA Belvoir Research, Development, and Engineering Center,
ATTN: STRBE-TSE, Fort Belvoir, VA 22060-5606 by using the self-addressed
Standardization Document Improvement Proposal (DD Form 1426) appearing at
the end of this document or by letter.
DISTRIBUTION STATEMENT A. Approved for public release, distribution is