 |
|||
|
|
|||
| ||||||||||
|
|  MIL-R-10509/3J
D
C
B
A
Dimension
Inches
mm
A
.750 +.125, -.250
19.05 +3.18, -6.35
1.500 .125
38.10 3.18
B
.032 .002
0.81 0.05
C
D
.250 +.125, -.090
6.35 +3.18, -2.29
NOTE:
1. Dimensions are in inches.
2. Metric equivalents are given for general information only.
3. The end of the body shall be that point at which the body diameter equals the nearest drill size
larger then 150 percent of the normal lead diameter, or 300 percent of the nominal lead diameter.
The same drill size shall be used for each end of the body.
4. The leads shall be solderable to within 0.062 (1.58 mm) of the resistor body.
FIGURE 1. Style RN70.
5. PACKAGING
5.1 Packaging. For acquisition purposes, packaging requirements shall be as specified in the contract
or order (see 6.2). When actual packaging of materiel is to be performed by DoD personnel, these
personnel need to contact the responsible packaging activity to ascertain requisite packaging
requirements. Packaging requirements are maintained by Inventory Control Point's packaging activity
within the Military Department or Defense Agency, or within the Military department's System Command.
Packaging data retrieval is available from the managing Military Department's or Defense Agency's
automated packaging files, CD-ROM products or by contacting the responsible packaging activity.
6. NOTES
6.1 Intended use. The notes specified in MIL-R-10509 are applicable to this specification.
3
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals