 |
|||
|
|
|||
| ||||||||||
|
|  MIL-R-10509/7H
2.2 Government documents.
2.2.1 Specifications, standards, and handbooks. The following specifications, standards, and
handbooks form a part of this document to the extent specified herein. Unless otherwise specified, the
issues of these documents are those listed in the issue of the Department of Defense Index of
Specifications and Standards (DoDISS) and supplement thereto, cited in the solicitation (see 6.2).
SPECIFICATIONS
DEPARTMENT OF DEFENSE
MIL-R-10509 - Resistors, Fixed, Film (High Stability), General Specification for.
(Unless otherwise indicated, copies of the above specifications, standards, and handbooks are
available from the Department Automation and Production Service, Building 4D, (DPM-DODSSP), 700
Robbins Avenue, Philadelphia, PA 19111-5094.)
2.3 Order of precedence. In the event of a conflict between the text of this document and the
references cited herein (except for related associated specifications, specification sheets, or MS sheets),
the text of this document takes precedence. Nothing in this document, however, supersedes applicable
laws and regulations unless a specific exemption has been obtained.
3. REQUIREMENTS
3.1 General. The requirements for acquiring the product described herein shall consist of this
document and MIL-R-10509.
3.2 Interface and physical dimensions. Resistors shall meet the interface and physical dimensions
specified on figure 1.
3.3 Power rating. The power rating shall be 0.1 watt. For characteristic D, the power rating shall be
0.125 watt.
3.4 Voltage rating. The maximum continuous working voltage shall not exceed 200 volts.
3.5 Resistance. Minimum and maximum resistance values shall be as follows in table I.
TABLE I. Minimum and maximum resistance.
Minimum resistance
Maximum resistance
Characteristics
Ohms
Characteristics
Megohms
D, G
10.0
D, G
.301
C, E
49.9
C, E
0.100
4. VERIFICATION
4.1 Sampling and inspection. Sampling and inspection shall be in accordance with MIL-R-10509.
4.2 Terminal strength. Direct load shall be applied gradually until the load reaches 2 pounds.
2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals