Click here to make tpub.com your Home Page

Page Title: Appendix A Procedure for Qualification Inspection
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home

   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 




img
MIL-R-19365D
APPENDIX A
PROCEDURE FOR QUALIFICATION INSPECTION
A.1. SCOPE
A.1.1 Scope. This appendix details the procedure for submission of sample, with test results, for
qualification inspection of resistors covered by this specification. The proc edure for extending
qualification required sample to other resistors covered by this specification is also outlined herein. This
appendix is a mandatory part of the specification. The information contained herein is intended for
compliance.
A.2. APPLICABLE DOCUMENTS
This section is not applicable to this appendix.
A.3. SUBMISSION
A.3.1 Sample. A sample consisting of 12 coated or enclosed sample units, of the styles specified in
column 1 of table VIII of the highest resistance value and using a nominal diameter wire of .004 inch (0.10
mm), shall be submitted for each style for which qualification is sought. If the same coating and material
are not used, a separate submission shall be furnished for each coating and material for which
qualification is sought. Four uncoated or unenclosed sample units shall also be submitted in each style
specified in column 1 of table VIII. If enclosures are used in lieu of coatings, four enclosures shall also be
furnished. Sample units shall be submitted complete with supplementary insulation and mounting
hardware normally used for mounting the resistors. The submitted samples shall be representative of the
supplier's normal production.
A.4. EXTENT OF QUALIFICATION
A.4.1 Extent of qualification. Qualification of a particular style and resistance value will qualify a range
of resistance values from the smallest value listed in the style (see A.3.1) to the resistance value tested.
In addition, qualification of one style will be the basis for qualification of another style (or styles), as
specified in table VIII.
TABLE AI. Style qualification.
Style
Styles qualified
RX29
RX29
RX32
RX29,
RX32
RX33
RX29,
RX32, RX33
RX35
RX29,
RX32, RX33, RX35
RX36
RX36
RX37
RX36,
RX37
RX38
RX36,
RX37, RX38
RX47
RX36,
RX37, RX38, RX47
26

Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business