 |
|||
|
|
|||
| ||||||||||
|
|  MIL-R-24414D(SH)
3.12 Painting The reals shall be treated, primed, and painted in accor-
dance with MIL-T-704.
In addition, exterior surfaces shall be given two coats of
enamel in accordance with TT-E-489. The finish enamel shall be red, color number
11105 of FED-STD-595.
Screw threads shall be in accordance with FED-STD-H28.
rew
.
3.13
3.14
Identification
Equipment
assemblies
and
parts
shall
be
marked in accordance with MIL-STD-130. The size of the hose to be used shall be
stamped on each reel.
property Upon request from the contractor, hose for
3.15 Government-loaned
the test specified in 4.7.1 will be furnished by the Government (see 6.6).
Parts shall be smoothly finished and free of
3.16 Workmanship
imperfections which may impair serviceability.
4.
QUALITY ASSURANCE PROVISIONS
Unless otherwise specified in the
4.1
Responsibilty
contract or purchase order, the contractor is responsible for the performance of
Except
all inspection requirements (examinations and tests) as specified herein.
as otherwise specified in the contract or purchase order, the contractor may use
his own or any other facilities suitable for the performance of the inspection
requirements specified herein, unless disapproved by the Government. The
Government reserves the right to perform any of the inspections set forth in this
specification where such inspections are deemed necessary to ensure supplies and
services conform to prescribed requirements.
4.1.1 Responsi b ility for compli ante . All items shall meet all requirements
o
o
of sections 3 and 5. The inspection set forth in this specification shall become
a part of the contractor's overall inspection system or quality program. The
absence of any inspection requirements in the specification shall not relieve the
contractor of the responsibility of ensuring that all products or supplies
submitted to the Government for acceptance comply with all requirements of the
contract.
Sampling inspection, as part of the manufacturing operations, is an
acceptable practice to ascertain conformance to requirements, however, this does
not authorize submission of known defective material, either indicated or actual,
nor does it commit the Government to accept defective material.
4.2
ectio ns.
The inspection requirements specified
cation of
herein are classified as follows:
(a) First article inspection (see 4.3).
(b) Quality conformance inspection (see 4.4).
4.3 First article inspection. One reel of each type being acquired shall
be subjected to first article inspection and tests.
First article inspection
shall consist of the examination and tests specified in Table IV.
9
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals