 |
|||
|
|
|||
| ||||||||||
|
| MIL-R-45012E
( b ) . Manually examine to assure that the trigger guard latches
t o the housing securely retain the firing mechanism to the rifle (see
3 . 3 . 8 and 3.3.8.5).
(c) Insert a dummy round in the magazine before reassembling
t h e magazine to the rifle. Assemble the magazine to the rifle to
assure that it will assemble without manual depression of the magazine
l a t c h (see 3.3.11).
( d ) Manually withdraw the operating rod and bolt to the
o p e n (rearward) position and allow to return to the closed position
u n d e r spring action to determine proper stripping of the cartridge from
the magazine by the bolt.
( e ) Manually withdraw the operating rod and bolt to the open
p o s i t i o n to determine proper extraction and ejection of the cartridge
( s e e 3.3.4.2 and 3.3.4.3).
( f ) With the magazine assembled, examine centrality of
c a r t r i d g e clip guide with the magazine opening using inspection equip-
ment in accordance with Drawing D11015522 (see 3.3.1.2).
( g ) With the magazine removed, the rifle set for semi-automatic
f i r e} t h e s a f e t y i n t h e " o f f " position, and the trigger depressed, the
hammer shall not fall when the rifle is charged and the rear of the
connector is pushed forward (see 3.3.15).
4 . 4 . 2 . 2 . 2 3 Rifles which have passed all examinations after successful
completion of testing shall be stamped by the contractor with the Depart-
ment of Defense complete inspection approval stamp as specified on the
a p p l i c a b l e drawing. The Government representative will observe the stamping
operation and control the stamps used for such stampings.
4 . 4 . 2 . 3 Packaging. E x a m i n a t i o n of packaging Of rifles shall be
p e r f o r m e d in accordance with the classification of defects and acceptable
q u a l i t y levels (AQL's) specified in 4.4.2.3.1 (see 6.1). Sample size
s h a l l be in accordance with MIL-STD-105, using inspection level I. The
f o l l o w i n g provisions shall apply:
( a )lT h e AQL's are specified as percent defective.
( b ) The AQL listed for each defect shall reapplied to the
i n d i v i d u a l defect, not to a group of defects.
( c ) Examination for packaging defects specified in 4.4.2.3.1
s h a l l apply to each sample of rifles, interior packages, or exterior
c o n t a i n e r s , as applicable.
16
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals