 |
|||
|
|
|||
| ||||||||||
|
|  MIL-R-46837B (MI)
3.8 Workmanship. Raceways surfaces shall be free of foreign matter, contain
no sharp edges or burrs, and shall be smooth with uniform color. There shall be no
cracks or splits in the material, however, slight enamel crazing or scoring on the
raceway may be acceptable.
4. QUALITY ASSURANCE PROVISIONS
4.1 Responsibility for inspection. Unless otherwise specified in the contract or
purchase order, the contractor is responsible for the performance of all inspection
requirements (examinations and tests) as specified herein. Except as otherwise
specified in the contract or purchase order, the contractor may use his own or any other
facilities suitable for the performance of the inspection requirements specified herein,
unless disapproved by the Government. the Government reserves the right to perform
any of the inspections set forth in this specification where such inspections are deemed
necessary; to assure supplies and services conform to prescribed requirements.
4.1.1 Responsibility for compliance. All items shall meet all requirements of
sections 3 and 5. The inspection set forth in this specification shall become a part of
the contractor's overall inspections system or quality program. The absence of any
inspection requirements in the specification shall not relieve the contractor of the
responsibility of ensuring that all products or supplies submitted to the Government for
acceptance comply with all requirements of the contract. Sampling inspection, as part
of manufacturing operations, is an acceptable practice to ascertain conformance to
requirements, however, this does not authorize submission of known defective
material, either indicated or actual, nor does it commit the government to accept
defective material.
4.2 Inspection.
4.2.1 Inspection lot. A lot, for inspection purposes, shall consist of raceways
that are the same material, type, finish, size and manufactured under essentially the
same conditions.
4.2.2 Quality conformance inspection. Unless otherwise specified (see 6.2),
quality conformance inspection shall be conducted in accordance with Table V.
Quality conformance inspection shall be applied to each lot of completed items being
offered for fulfillment of the contract. Quality conformance inspections shall consist
of the following:
a.
Examination (4.2.2.1)
b.
Tests (4.2.2.2)
c.
Packaging inspection (4.2.2.3)
7
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals