 |
|||
|
Page Title:
Government furnished inspection equipment |
|
||
| ||||||||||
|
|  MIL-R0-48577(MU)
4.3.4.2 Three assemblies shall be selected at random as samples
from each 50 produced, or from each month's production, whichever occurs
first. Each sample shall meet the requirements and tests in Table IV and
shall then meet the requirements and tests in Table I.
TABLE IV
TEST PROCEDURE
REQUIREMENT
NO.
CHARACTERISTIC
3.3.1
4.5.1
303. Storage temperature
3.3.2
4.5.2
304. Operating temperature
4.5.3
3.3.3
305. Shock
4.3.4.3 Three assemblies shall be selected at random as samples
from production lots at the 25 percent, 50 percents and 75 percent comple-
tion interval of each production order or contract. Each sample shall
meet the requirements and tests in Table V and shall then meet the
requirements and tests in Table I.
TABLE V
TEST PROCEDURE
REQUIREMENT
CHARACTERISTIC
NO.
4.5.4
3.3.4
306. Vibration "A"
4.3.4.4 Failure of sample.- Should any one item of a special
sampling fail to meet the specified test requirements, acceptance of
the represented inspection lot shall be suspended by the Government
until necessary corrections have been made-by the contractor and the
resubmitted items have been approved (see 4.3.3).
4.4 Inspection equipment.- Except as otherwise provided for by
the contract, the contractor shall supply and maintain inspection
equipment in accordance with the applicable requirements of MIL-1-45607.
4.4.1 Government furnished inspection equipment.- Where the
contract provides for Government furnished test equipment, supply and
maintenance of test equipment shall be in accordance with applicable
requirements specified in MIL-I-45607.
4.4.2 Contractor furnished inspection equipment.
4.4.2.1 Government design.- All inspection equipment specified by
drawing number in specification or SQAP forming a part of the contract
shall be supplied by the contractor in accordance with technical data
included in the technical data package list.
4.4.2.2 Contractor design.- The contractor shall design and supply
inspection equipment compatible with 4.4.2.3, the "Test Methods and Proce-
dures" specified in 4.5 of this specification and with the component in-
spection-procedures specified in "Examination" and "Test Facilities"
requirements of MIL-F-13926. Since tolerance of test equipment is normal-
ly considered to be within 10% of the product tolerance for which it is
intended, this inherent error in the test equipment design must be consi-
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals