Terminal strength: 2 pounds axial pull.
Terminal solderability: Applicable.
Sealed by welding: Not applicable.
Dimensions and configuration: See figure 1.
Termination: Pin type (PC).
Marking: See figure 1.
1 pole - 12 grams max.
2 pole - 18 grams max.
3 pole - 22 grams max.
4 pole - 24 grams max.
LIFE TEST REQUIREMENTS:
High level: See table II for number of operations and cycling rate.
Low level: See table II.
Minimum current: 20,000,000 operations at 900 to 1,200 operations per minute.
Quality conformance inspection:
Periodic inspection: Groups B and C inspections are not required.
Subgroup 1: Applicable for low level loads only at a rate of approximately 60 operations/second.
Subgroup 2: 100 percent.
Dielectric withstanding voltage: Test to be conducted at sea level rating only. Duration of application shall be 5 to 10
seconds at a 10 percent increase in the dielectric strength voltage.