Rubber, Synthetic, Sheets, Strips, Molded or Extruded Shapes, General Specification

• Rubber, Synthetic, Sheets, Strips, Molded or Extruded Shapes, General Specification
• Applicable Documents
• Non-Government publications
• Dimensions and tolerances
• Table IV. Rod tolerances
• Table V. Physical and mechanical properties - Classes 1, 2 and 3
• Table VI. Physical and mechanical properties - Classes 4 and 5
• Identification marking
• Responsibility for compliance
• Table VII. First Article tests
• Quality conformance inspection
• Examination of Packaging
• Physical and mechanical property tests
• Table X. Quality conformance physical and mechanical tests
• Crazing test
• Change in hardness
• Change in tensile strength
• Fuel immersion
• Packaging
• Shelf life markings
• Palletization
• Acquisition requirements
• Consideration of data requirements
• Acceptance criteria
• Figure 1. Sketch showing typical stress crazing beam
• Standardization Document Improvement Proposal
• Blank Page

Rubber, Synthetic, Sheets, Strips, Molded or Extruded Shapes, General Specification

Privacy Statement - Press Release - Copyright Information. - Contact Us