 |
|||
|
Page Title:
Check the auto ripple release mode. |
|
||
| ||||||||||
|
| MIL-R-85323(AS)
4.
Open the forward
ejector unit and
+0.794
place a 5.55 -0
inch)
(7/32 -0
spacer between the hook toe and the ejector
housing as shown in Figure 2. The lamp shall
illuminate at this hook position.
o.
Check the auto ripple release mode.
1.
Apply the test voltage to pin 4 and pin 7 of
connector J1.
2.
Hold the step-home switch in the homing position.
The stepper switch shall go to the home position
and the homing light shall illuminate.
Place the selector switch to the auto ripple
3.
mode.
4.
Apply the test voltage to pin 8 of connector
J1. The stepper switch shall continuously
operate, providing firing pulses to each ejec-
tor unit station of the bomb rack. The stepper
switch shall continue to operate with the test
voltage applied to pin 8.
Remove all voltages from connector J1.
5.
Check the mechanical step release mode.
p.
1.
Apply the test voltage to pin 4 and pin 7 of
connector J1.
2.
Hold the step-home switch in the homing posi-
tion. The stepper switch shall go to the home
position and the homing light shall illuminate.
Momentarily apply the test voltage to pin 9
3.
(positive) of connector J1.
The stepper switch shall step one station for
4.
each application of the test voltage to pin 9
of the J1 connector.
Check to ensure that
voltage does not exist at the station where the
stepper switch is located.
Remove all voltages from connector J1.
5.
18
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals