5 October 2001
22 November 1968
RESISTORS, FIXED, WIRE WOUND (ACCURATE),
INACTIVE FOR NEW DESIGN AFTER 22 NOVEMBER 1968.
This specification is approved for use by all Departments
and Agencies of the Department of Defense.
1.1 Scope. This specification covers the requirements for style RB70, accurate, wire wound, fixed
1.2 Part or Identifying Number (PIN). Resistors covered by this specifi cation are identified by a PIN
which consists of the style of this specification and a coded number. The PIN is in the following form:
2 APPLICABLE DOCUMENTS
2.1 General. The documents listed in this section are specified in sections 3 and 4 of the specification.
This section does not include documents cited in other sections of this specification or recommended for
additional information or as examples. While every effort has been made to ensure the completeness of
this list, document users are cautioned that they must meet all specified requirements documents cited in
sections 3 and 4 of this specification, whether or not they are listed.
Beneficial comments (recommendations, additions, deletions) and any pertinent data which may be of
use in improving this document should be addressed to: Defense Supply Center, Columbus, ATTN:
DCSS -VAT, Post Office Box 3990, Columbus, Ohio 43216-5000, by using the Standardization
Document Impr ovement Proposal (DD Form 1426) appearing at the end of the document or by letter.
DISTR IBUTION STATEMENT A. Approved for public release; distribution is unlimited.