 |
|||
|
|
|||
| ||||||||||
|
| MIL-S-1419D (PA)
102.
Burr or chip on or at inter-
section or other functional
surfaces . . . . . . . . . . . . . . . . . . . . . . Visual/Manual
Finish of sliding or other
1030
functional surface improper ... Visual
104.
Component missing or improperly
assembled . . . . . . . . . . . . . . . . . . . . . Visual
105.
Protective finish missing
or contains bare spot . . . . . . . . . visual
Minor;
AQL 0.65 percent
201.
Evidence of poor workmanship
other than that covered under
Major category above (see 3.7). Visual
4.3.3 Production Testing
4.3.3.1 Moisture content (see Table I) Major defects
TABLE I
Material
Code No.
Star charge composition (see 3.3.1)
12001
Black powder (see 3.3.2)
12002
Felt (see 3.3.4)
12003
Paper (see 3.3.3)
Chipboard (see 3.3.3)
12005
The contractor shall provide adequate controls to insure that
the materials comply with the requirements. For verification,
the contractor shall select and test one sample of each material
used in each eight hours production. A composite sample shall
not be used. If the moisture content of a sample exceeds the
requirement and loadlng has not begun, the material represented
by the sample shall be rejected. If components have been loaded
with material containing excessive moisture, the loaded components
and the remaining unloaded material shall be rejected. Test pro-
cedures shall be as specified in 4.4.1. The sample of star charge
composition shall be selected prior to consolidating the star
assemblies.
4.3.3.2 Transporation vibration.- The signal assemblies
shall be observed and examined visually without disassembly for
any evidence of failure to comply with the requirements as
classified in Table II.
16
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals