 |
|||
|
|
|||
| ||||||||||
|
|  MIL-S-22518A(AS)
All dimensions, clearances, and fits.
1.
Materials, treatment and finishes (identify
2.
each by specification number).
Construction.
3.
4.
Characteristics and ratings.
A complete set of level 3 production drawings
d.
and associated lists in accordance with DOD-D-1000.
e.
Packing requirements and packing drawings for
the ATS/AD.
ALL contractor specifications listed in the
f.
manufacturing drawings.
Tests. The qualification tests shall consist of the
4.3.2
tests specified under 4.5 and listed in Table I, conducted on the applicable
specimens. The tests to be conducted on each ATS/AD shall be determined
by the qualifying activity. If considered desirable by the qualifying
activity, the qualification test may be supplemented with tests under
actual or simulated service conditions, provided they are not in contradiction
to the requirements specified herein. The qualifying activity reserves
the right to disassemble the ATS/ADs partially or completely before,
during, and after the qualification test.
4.3.3
The retention of qualification shall
Retention.
consist of periodic verification to determine compliance of the qualified
ATS/AD with the requirements of this specification. Verification shall
be conducted at intervals not exceeding 2 years.
Quality conformance
Quality conformance inspection.
4.4
inspection shall consist of the following:
Individual inspection (4.4.1).
4.4.1
Individual inspection. The inspection test of the
ATS/AD shall consist of the tests described herein for the following:
a.
Rated torque calibration test (4.5.9).
b.
Overrunning speed test (4.5.10).
The airflow at the stall condition shall be
c.
measured (4.5.4). During this check, rotation of the ATS/AD output
shaft shall not exceed 200 rpm.
15
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals