 |
|||
|
Page Title:
Rotation viewed from anti-output shaft end |
|
||
| ||||||||||
|
|  MIL-S-22999/l(AS)
0.726/0.736 inches
Minor Diameter
Major Diameter
0.845/0.850 inches
0.072/0.077 inches
Tooth Thickness Circular
0.1571
Circular Pitch
The male starter spline shall extend .971 inches maximum
from the starter mounting flange face and shall have
.430 .010 inches for the overall length of the spline
teeth. A clearance hole shall be provided in the end
of the starter spline with a minimum diameter of .540 inches
and a minimum depth from the spline end of .187 inches.
Counterclockwise
Rotation viewed from anti-output shaft end:
Ports:
Conform to:
Inlet - MS33649-8; Outlet - MS33649-8
-65 to +275
Ambient temperature operating range (oF):
Exposure temperature range (F): -103 to +275
13,000
Overspeed limit, min peak no-load speed (rpm):
4400
Inlet pressure, max at zero flow (psig):
Rated inlet pressure (psig):
3750; +50, -o
Rated outlet pressure (psig):
50; +15, -o
Rated inlet fluid temperature (F): +275; +0, -10
Rated fluid flow (gpm): 9.0; maximum allowable flow at no-
load operation is 9.0 gpm.
Rated torque (lb-ft): 12 at 3700 psig differential pressure,
8.5 at 2750 differential pressure.
Rated drive shaft speed (rpm):
6000
Automatic shutoff control: Cutout switch shall be normally
open; it shall close upon application of hydraulic oil pressure
and open at cutout speed. The switch shall withstand a surge
current of 2 amperes at 28 volts inductive load at -65'F.
12,000; +500, -500
Drive shaft cutout speed (rpm):
Initial calibration:
Hydraulic fluid flow, max (gpm):
Zero to max cutout drive speed: 9.0
No-load drive speed: 9.O
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals