 |
|||
|
|
|||
| ||||||||||
|
|  MIL-S-45152H
contractor's inspection are being properly applied. Failure of the contractor to promptly correct
product deficiencies discovered shall be cause for suspension of acceptance until correction has
been made or until conformance of product to specification criteria has been demonstrated.
4.3 First production vehicle inspection. The first vehicle produced under the contract shall
be inspected by the contractor at his plant under the direction and in the presence of Government
representatives. When specified (see 3.21.1.1), weld specimens shall be used by as a guide in
determining the quality of all applicable welds. All welds on the first production vehicle and on
all subsequent production vehicles under the contract shall be compared with applicable weld
workmanship specimens prior to priming or painting the vehicle. Acceptance of the first vehicle
shall not constitute a waiver by the Government of its rights under the provisions of the contract.
4.3.1 Semitrailer weight. The semitrailer shall be weighed to determine curb weight and
distribution of curb weight on the kingpin and the rear axles. The imposed loading on the
kingpin and rear axles, with payload, shall be computed using curb weight and the semitrailer
payload distributed as specified in 3.3. The rated capacity of the axles, suspension system and
tires shall be compared to the loads imposed to determine if they conform to contract
requirements.
* 4.3.2 Normal road test. Unless an extended road test is specified (see 4.3.3), the first vehicle
for each contract line item number (CLIN) under contract; except sizes 50, 60 and 75
(see 4.3.10); shall be road tested with and without payload. The road test shall be for the
distance required in table V, corresponding to the number of vehicles being procured under the
specific contract line item number (CLIN). The test shall be conducted by the contractor under
the direction of Government representatives. The test shall be conducted over a test course
approved by the procuring activity and meeting the requirements of table VI. The vehicle shall
be inspected periodically during and at the completion of the test by the contractor.
TABLE V. Road test mileage.
Number of vehicles
Mileage of
being procured
road test
100
1 - 10
11 - 20
200
300
21 - 30
400
31 - 40
41 - 50
500
1000
51 - 100
5000
100 - up
27
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals