|
| ![]() MIL-S-52506D(ME)
30 July 1992
SUPERSEDING
MIL-S-52506C(ME)
27 December 1984
MILITARY SPECIFICATION
SEALS, SHAFT, MECHANICAL, LOW-PRESSURE TYPE,
SELF-LUBRICATING:
FOR GENERAL-PURPOSE CENTRIFUGAL PUMPS
This specification is approved for use within the USA Belvoir Research,
Development and Engineering Center, Department of the Army, and is available for
use by all Departments and Agencies of the Department of Defense.
1.
SCOPE
This specification covers four types and 16 sizes of low-pressure,
1.1 Scope.
self-lubricating, mechanical shaft seals, commonly used on centrifugal pumps.
The seals shall be of the following types and sizes, as
1.2 Classification.
specified (see 6.2):
Type
I
- Pressed-in type with stationary sealing washer and rotating
seating surface (see figure 1).
Size
3
-
for
0.375-inch
diameter
shafts.
-
for
0.500-inch
diameter
shafts.
Size
4
-
for
0.625-inch
diameter
shafts.
Size
5
Size
6
-
for
0.750-inch
diameter
shafts.
Type
II
- Short-length type with rotating sealing washer and stationary
seating surface (see figure 2).
-
for
0.375-inch
diameter
shafts.
Size
3
-
for
0.500-inch
diameter
shafts.
Size
4
Size
5
-
for
0.625-inch
diameter
shafts.
-
for
0.750-inch
diameter
shafts.
Size
6
Size
7
-
for
0.875-inch
diameter
shafts.
-
for
1.000-inch
diameter
shafts.
Size
8
Size
8-1/2
-
for
1.062-inch
diameter
shafts.
-
for
1.125-inch
diameter
shafts.
Size
9
Size
10
-
for
1.250-inch
diameter
shafts.
Beneficial comments (recommendations, additions, deletions) and any pertinent
data which may be of use in Improving this document should be addressed to:
USA Belvoir Research, Development, and Engineering Center, ATTN: SATBE-TSE,
Fort Belvoir, VA 22060-5606 by using the Standardization Document Improvement
Proposal (DD Form 1426) appearing at the end of this document or by letter.
FSC 4320
AMSC N/A
DISTRIBUTION STATEMENT A. Approved for public release; distribution is unlimited.
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |