 |
|||
|
|
|||
| ||||||||||
|
|  MIL-S-777B(MU)
and resubmittance of rejected lots shall be in accordance with "Acceptance
and Rejection" as specified in MIL-STD-105.
4.3.3 Acceptance and rejection.- Rejected lots shall be screened for
all defective characteristics. Removal or correction of sefctive units
and resubmittance of rejected lots shall be in accordance with "Acceptance
and Rejection" as specified in MIL-STD-105.
4.4 Control tests.
4.4.1 Special sampling.- Samples shall be selected from lots at ran-
dom using inspection level S-3 Table I of MIL-STD-105. Acceptance or
rejection of the lot shall be in accordance with AQL 2.5 of Table II-A of
MIL-STD-105. The samples shall have met all the requirements and tests
outlined in Table I prior to and after being subjected to the following
examinations and tests,
TABLE II
REQUIREMENT
TEST PROCEDURE
CHARACTERISTIC
4.6.5
3.4.1
301.
Storage at extreme temperature
4.4.1.1 Failure of sample.- Should any one item of a special sampling
fail to meet the specified test requirements. acceptance of the product
shall be suspended by the Government until necessary corrections have been
made by the contractor and resubmitted samples have been approved (see
4.3.3).
4.4.2 First article sample.- Unless otherwise specified in the contract.
test(s) listed herein shall be conducted on one unit of the initial produc-
tion sample and shall not again be performed on the remaining production
quantities, provided the manufacturing processes and techniques used to
produce the samples have not been changed or revised.
REQUIREMENT
TEST PROCEDURE
CHARACTERISTIC
4.6.6
3.4.3
302.
Rain
4.4.3 Certification.- Certification shall include test data and re-
sults for all characteristics specified in Table III. Certification shall
be provided prior to performing final acceptance inspection, and remain in
effect throughout the contract for Government acceptance. This does not
relieve the contractor from inspection throughout the contract production,
including recording data and results therefrom. Recorded data and results
shall be made available to the Government upon request. A new certification
will be required should any changes occur in materials, manufacturing
processes and techniques previously certified.
TABLE III
TEST DATA TO
COMPLY WITH
REQUIREMENT
CHARACTERISTIC
3.1
Applicable drawings
Materials
Standards, & Specifications
5
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals