 |
|||
|
Page Title:
Other Government documents, drawings, and publications |
|
||
| ||||||||||
|
|  MIL-S-85892(AS)
(Unless otherwise indicated, copies of federal and military specifications,
standards, and handbooks are available from the Naval Standardization Documents
Order Desk, Bldg 4D Robbins Avenue, Philadelphia, PA 19111-5094.)
2.1.2 Other Government documents, drawings, and publications. The following
other Government documents, drawings, and publications form a part of this
document to the extent specified herein. Unless otherwise specified. the issues
are those cited in the solicitation.
DRAWINGS
NAVAL AIR SYSTEMS COMMAND (NAVAIR) (CAGE Code 30003)
1335AS257
Breech Hole Shield
Simulator, Surface-to-Air Missile, SMU-124/E
1335AS390
(Smokey SAM Simulator)
(Unless otherwise indicated, copies of Naval Air Systems Command drawings
are available from the Naval Air Technical Services Facility (NATSF) (Code 3121),
700 Robbins Avenue, Philadelphia, Pa 19111-5096. )
2.2 Order of precedence
In the event of a conflict between the text of this
document and the references cited herein, the text of this document takes
precedence. Nothing in this document, however, supersedes applicable laws and
regulations unless a specific exemption has been obtained.
REQUIREMENTS
3.
The Smokey SAM Simulator, see Drawing 1335AS390, shall meet the requirements of
section 3 of MIL-R-85545 and MIL-I-85547. The breech hole shield shall meet the
requirements of Drawing 1335AS257.
4. QUALITY ASSURANCE PROVISIONS
4.1 Responsibility for inspection. Unless otherwise specified in the contract
or purchase order, the contractor is responsible for the performance of all
inspection requirements (examinations and tests) as specified herein. Except as
otherwise specified in the contract or purchase order, the contractor may use his
own or any other facilities suitable for the performance of the inspection
requirements specified herein, unless disapproved by the Government. The
Government reserves the right to perform any of the inspections set forth in this
specification where such inspections are deemed necessary to ensure supplies and
services conform to prescribed requirements.
4.1.1 Responsibility for compliance. All items shall meet all requirements of
sections 3 and 5. The inspection set forth in this specification shall become a
part of the contractor's overall inspection system or quality program. The
absence of any inspection requirements in the specification shall not relieve the
contractor of the responsibility of ensuring that all products or supplies
submitted to the Government for acceptance comply with all requirements of the
contract. Sampling inspection, as part of manufacturing operations, is an "
acceptable practice to ascertain conformance to requirements, however, this does
not authorize submission of known defective material, either indicated or actual,
nor does it commit the Government to accept defective material.
The remainder of section 4 shall be in accordance with section 4 of MIL-R-85545
and MIL-I-85547.
2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals