 |
|||
|
|
|||
| ||||||||||
|
|  MIL-T-11663K
parts connected by the welds. Welds shall transmit stress without permanent deformation or
failure when the parts connected by the welds are subject to proof and service loadings. Fillet
welds shall be provided when necessary to reduce stress concentration.
4. QUALITY ASSURANCE PROVISIONS
4.1 Responsibility for inspection. Unless otherwise specified in the contract, the contractor is
responsible for the performance of all inspection requirements as specified herein. Except as
otherwise specified in the contract, the contractor may use his own or any other facilities suitable
for the performance of the inspection requirements specified herein, unless disapproved by the
Government. The Government reserves the right to perform any of the inspections set forth in the
specification where such inspections are deemed necessary to assure supplies and services
conform to prescribed requirements.
* 4.1.1 Responsibility for compliance. All items must meet all requirements of sections 3 and 5.
The inspection set forth in this specification shall become a part of the contractor's overall
inspection system or quality program. The absence of any inspection requirements in the
specification shall not relieve the contractor of the responsibility for assuring that all products or
supplies submitted to the Government for acceptance comply with all requirements of the
contract. Sampling in quality conformance does not authorize submission of known defective
material, either indicated or actual, nor does it commit the Government to acceptance of defective
material.
4.2 Government verification. Quality assurance operations performed by the contractor will
be subject to Government verification at unscheduled intervals. Verification will consist of
observation of the operations to determine that practices, methods and procedures of the
contractor's inspection are being properly applied. Failure of the contractor to promptly correct
product deficiencies discovered shall be cause for suspension of acceptance until correction has
been made or until conformance of the product to specification criteria has been demonstrated.
4.3 First production vehicle inspection. The first vehicle of each type and class (see 1.2)
produced under the contract shall be subjected to an inspection and a road test. The inspection
and road test shall be conducted by the contractor, at or near his plant, under the direction and in
the presence of Government representatives. Acceptance of the first production vehicle shall not
constitute a waiver by the Government of its rights under the contract.
22
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals