Low temperature, operating

Page Title: Low temperature, operating
Back | Up | Next

Web
www.tpub.com

Information Categories

....

MIL-T-22913C(OS)

3.4.2.4 Low temperature, operating. The timer shall be capable of

meeting all the performance requirements of this specification while

undergoing the test specified in 4.4.2.4.

305 Cleanup. Prior to and after final assembly, all parts, components,

and the assembly shall be thoroughly cleaned of loose, spattered, or

excess solder, metal chips, and other foreign matter. Burrs and sharp

edges, as well as rosin flash, shall be removed.

3.6 Workmanship. The equipment, including all parts and accessories,

shall be constructed and finished in a reamer to ensure compliance with

all requirements of this specification. Particular attention shall be

paid to neatness and thoroughness of soldering, wiring, marking of parts,

and assemblies, impregnation of coils, plating, painting, machine screw

assemblage, welding, riveting, brazing, and freedom of parts from all

burrs and sharp edges. The standards of workmanship exhibited in any

approved preproduction sample, subject to any qualification stated in

the Government's notice of approval, shall be determinative of the re-

quirements of the contract relative to workmanship insofar as not

specifically covered by applicable specifications.

4. QUALITY ASSURANCE PROVISIONS

4.1 Responsibility for inspection. Unless otherwise specified in the

contract or purchase order, the supplier is responsible for the perform-

ance of all inspection requirements as specified herein. Except as other-

wise specified in the contract or order, the supplier may use his own or

any other facilities suitable for the performance of the inspection re-

quirements specified herein, unless disapproved by the Government. The

Government reserves the right to perform any of the inspections set forth

in the specification where such inspections are deemed necessary to assure

supplies and services conform to prescribed requirements.

4.2 Classification of inspections.

Inspection of the timer shall be

classified as follows:

(a) Reproduction inspection (paragraph 4.4)

(b) Quality conformance inspection (paragraph 4.5)

4.3 Sampling

4.3.1 Preproduction. A preproduction sample of five timers, manu-

factured in accordance with 3.2.2, shall be subjected to the preproduction

tests detailed in 4.4 at an activity designated by the procuring activity.

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business