 |
|||
|
Page Title:
SAE Standards and Recommended Practices |
|
||
| ||||||||||
|
|  MIL-T-26025E (USAF)
SOCIETY OF AUTOMOTIVE ENGINEERS, INC. (SAE)
SAE Standards and Recommended Practices
Minimum Performance Criteria for Emergency Steering of
Wheeled Earth Moving Construction Machines
Headlamps for Industrial Equipment
Vehicle Grade Parking Performance Requirements
Operator Controls on Industrial Equipment
Trucks, Truck Tractors, and Trailers, Air Brake Gladhand
Service (Control) and Emergency (Supply) Line Couplers
Sound Level for Truck Cab Interior
Motor Vehicle Grade Parking Performance Test Code
Exterior Sound Level for Heavy Trucks and Buses
Lubrication Fittings
Location and Operation of Instruments and Controls in
Motor Truck Cabs
Tire Chain Clearance - Truck, Buses and Combinations of
Vehicles
Certificates of Maximum Horse Power for Motor Trucks and
Truck Tractors
USA Human Physical -Dimensions
Operator's Seat Dimensions - Construction and Industrial
Equipment Design
Sound Level Measurements at the Operator Station for
Agricultural and Construction Equipment
Brake System Performance Requirements - Truck, Bus and
Combination of Vehicles
Fuel Economy Measurement Road Test Procedure
General Requirements for Aerospace Ground Support
Equipment Motorized and Non-motorized
Engine Power Test Code - Spark Ignition and Diesel
(Application for copies should be addressed to the Society of Automotive Engineers, 400
Commonwealth Drive, Warrendale PA 15096).
Order of preceden ce. In the event of a conflict between the text of this specification and the
2.3
references cited herein (except for associated detail specifications, specification sheets or MS standards),
the text of this specification shall take precedence. Nothing in this specification, however, shall supersede
applicable laws and regulations unless a specific exemption has been obtained.
3.
REQUIREMENTS.
3.1
Design.
Selection of specifications and standards. Specifications and standards, necessary
3.1.1
commodities and services not specified herein shall be selected in accordance with MIL-STD-143.
3.1.2
Materials shall be as specified herein. Materials not specifically covered by this
specification or referenced document shall be suitable in every respect for this type equipment. Except as
otherwise specified, wood shall not be used.
3.1.2.1 Protective treatment.
Materials that are subject to deterioration shall be protected in such a
manner that shall in no way prevent compliance with the performance requirements of this specification.
Protective coatings that will chip, crack or scale with age or extremes of climatic conditions shall not be
used.
4
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals