 |
|||
|
Page Title:
Tube,Steel:Pipeline Section;with Grooved Nipple Welded on Each End |
|
||
| ||||||||||
|
|  INCH-POUND
MIL-T-425J
16 December 1994
SUPERSEDING
MIL-T-425H
22 December 1986
MILITARY SPECIFICATION
TUBE, STEEL: PIPELINE SECTION; WITH GROOVED
NIPPLE WELDED ON EACH END
This specification is approved for use by all Departments and Agencies of the Department of
Defense.
1. SCOPE
1.1 Scope. This specification covers thin wall steel pipe with a grooved pipe nipple welded on
each end.
1.2 Classification. Pipeline sections shall be of the following sizes, as specified (see 6.2):
Nominal pipe size
Outside diameter
2-inch
2.375-inch
4-inch
4.500-inch
6-inch
6.625-inch
8-inch
8.625-inch
12-inch
12.750-inch
2. APPLICABLE DOCUMENTS
2.1 Government documents.
2.1.1 Specifications and standards. The following specifications and standards form a part of
this specification to the extent specified herein. Unless otherwise specified, the issues of these
documents shall be those listed in the issue of the Department of Defense Index of Specifications
and Standards (DoDISS) and supplement thereto, cited in the solicitation (see 6.2).
Beneficial comments (recommendations, additions, deletions) and any pertinent data which may
be of use in improving this document should be addressed to: US ARMY MOBILITY
TECHNOLOGY CENTER BELVOIR, 10115 GRIDLEY RD STE 128, FT BELVOIR VA
22060-5843 by using the Standardization Document Improvement Proposal (DD Form 1426)
appearing at the end of this document or by letter.
AMSC N/A
FSC 4710
DISTRIBUTION STATEMENT A. Approved for public release, distribution is unlimited.
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals