 |
|||
|
Page Title:
Other Government documents, drawings, and publications |
|
||
| ||||||||||
|
| MIL-T-45499C
MIL-STD-109
Quality Assurance Terms And Definitions
MIL-STD-453
Inspection, Radiographic
MIL-STD-1168
Ammunition Lot Numbering
MS28741
Hose Assembly, Detachable End Fitting, Medium Pressure
(Unless otherwise indicated, copies of federal and military specifications and standards are available from
Standardization Documents Order Desk, Bldg. 4D, 700 Robbins Avenue, Philadelphia, PA 19111-5094.)
2.1.2 Other Government documents, drawings, and publications. The following Government
drawings form a part of this specification to the extent specified herein. Unless otherwise specified, the issues
are those cited in the solicitation (see 6.2).
DRAWINGS
Naval Surface Warfare Center, Indian Head (CAGE Codes 19200 and 19203)
DL8593854
Thruster, Cartridge Actuated, M1A2 Assembly
8593889
Cartridge, Impulse, M42A1 Assembly
8797631
Box, Fiberboard (Inner), Packing, Ammunition, For Thruster, Cartridge Actuated,
M1A2
8797632
Box, Packing, Ammunition, For Thruster, Cartridge Actuated, M1A2
9221261
Box, Fiberboard (Outer), Alternative, Packing Ammunition, for Thruster, Cartridge
Actuated, M1A2
U.S. Air Force
TPO 00-891-5488
Thruster, Cartridge Actuated, M1A2
(Application for copies should be addressed to: Commander, Indian Head Division, Naval Surface Warfare
Center, Attn: Data Control Branch (Code 8410), Indian Head, MD 20640-5035.)
2.2 Order of precedence. In the event of a conflict between the text of this document and the references
cited herein, the text of this document takes precedence. Nothing in this document, however, supersedes
applicable laws and regulations unless a specific exemption has been obtained.
3. REQUIREMENTS
3.1 Materials. All materials used in the manufacture of the thrusters shall conform to the specifications
referred to on the respective drawings unless specific approval in writing covering a departure therefrom has
been obtained from the cognizant Navy design activity prior to manufacture. When alternate materials or
methods of manufacture are specified on the drawings, the bidder's selections shall be clearly stated in the
proposal.
2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals